jonsky7 Posted September 4, 2022 Share Posted September 4, 2022 Hello, I bought the upgrade for my gunfighter Mk2 to make it a mk3 a while ago, only getting round to fitting it. I'm having a problem installing the new circuit board to the side of the gimbal. Basically my clutch is held together with a stud with a nut on it, and the nut is interfering with the installation of the board, have I been sent the wrong board? I did send pictures of the base as requested when ordering the upgrade. Am I supposed to just remove the nut? Please help, the official tutorial video does not show the same Mk2 as I have. Link to comment Share on other sites More sharing options...
fallout9 Posted September 4, 2022 Share Posted September 4, 2022 You could get rid of the nut, it's not needed with the new board. Link to comment Share on other sites More sharing options...
jonsky7 Posted September 7, 2022 Author Share Posted September 7, 2022 On 9/4/2022 at 6:57 PM, fallout9 said: You could get rid of the nut, it's not needed with the new board. Thanks, I figured I'd give it a go and all is well so far. 1 Link to comment Share on other sites More sharing options...
Recommended Posts