LaHitte Posted December 29, 2022 Posted December 29, 2022 I am using 2.8 and fly the F-18C. Within the last week or so, the SA page on the centre MFD does not work properly. Nor does the Autopilot. None of the waypoints I create in Mission Editor load into the aircraft and most of the soft keys around the screen to not work. Pressing the A\P button on the UFC does nothing. Though TCN and ILS show some symbology. I have attempted to create new missions from scratch but the same problem occurs. INS alignment shows good. I have checked with the Instant Action missions and the fault appears with these too. I have tried “Repair” and “Clean” from the DCS Updater but with no success. I have no idea whether there is any connection between these two events but my computer did a Windows 10 Update around about the time that this fault occurred with my DCS. If I have to do a complete reinstallation of DCS, will I lose all my control settings for the F-18, or is there a way I can save them - I am a humble driver-airframe so totally computer illiterate, they took me ages to set-up. Thanks for your help.
Sacarino111 Posted December 29, 2022 Posted December 29, 2022 30 minutes ago, LaHitte said: I am using 2.8 and fly the F-18C. Within the last week or so, the SA page on the centre MFD does not work properly. Nor does the Autopilot. None of the waypoints I create in Mission Editor load into the aircraft and most of the soft keys around the screen to not work. Pressing the A\P button on the UFC does nothing. Though TCN and ILS show some symbology. I have attempted to create new missions from scratch but the same problem occurs. INS alignment shows good. I have checked with the Instant Action missions and the fault appears with these too. I have tried “Repair” and “Clean” from the DCS Updater but with no success. I have no idea whether there is any connection between these two events but my computer did a Windows 10 Update around about the time that this fault occurred with my DCS. If I have to do a complete reinstallation of DCS, will I lose all my control settings for the F-18, or is there a way I can save them - I am a humble driver-airframe so totally computer illiterate, they took me ages to set-up. Thanks for your help. I can't tell about your issue, other may know, but about the controls, you can always save the configuration; In the setup tab, where you config your rig, right click on the column relative to the control you want to save, and in the menu tha will appear, select "save config". Save it and place it somewhere safe. When you want to recall it, just do the same bot clik on load instead of save. Hopeyou can solve your problem. Saludos. Saca111
Recommended Posts