Leap Motion - disappearing right hand

[Rosly]

Just bought a Leap Motion, so unsure if this is new bug or known issue.

My right hand is disappearing after few seconds of use of Leap Motion in DCS. Left hand works ok.
I tried to show/hide hands with keyboard shortcuts (this is probably new commands in DCS I suppose) but the problem is not connected with those being mistakenly activated. I mean right hand truly disappear because of some bug not that I click or activate some setting by mistake.

When I disable and reenable Leap Motion extension in DCS, right hand appears once again and work for some time. 
They it disappear again.

It is also not the problem with my Leap Motion tracker nor any VR setup as the Leap Motion works perfectly ok with other apps.
Also both hands are perfectly tracked in Leap Motion Control Panel app where you can look over the tracking when DCS is pulling the data.
It is something within DCS itself. Not in driver, tracking, operating system or Leap Motion config level.

I use official Gemini 5.7.2 driver from Ultra leap.

[Dentedend10]

Hi,

I have the same issue. 
when reading around it was suggested to set a larger deadzone for the stick as stick input might make the hand disappear. Haven’t had a chance to try it yet. 
Any other options?

[A.F.]

Which settings do you use: hands move HOTAS or hands do not move HOTAS?
 

[edmuss]

Set a deadzone on your joystick or enable the hands move stick option (there are caveats to using this option).

With the default settings as soon as control input is seen on the stick or throttle it hides the relevant hand. With the hands control option it's possible to virtually grab the hotas in the cockpit and that then gives control input but the hands wont be hidden at all.

I'm using hands use control (as I'm setting up a non centring cyclic and I like to be able to hold the stick position with my left hand whilst controlling MFDs etc) but with the hands enabled/disabled on a binding from the UI layer.