Mogster Posted January 26, 2009 Posted January 26, 2009 (edited) Since I installed BS I've been having problems with trim and MSFF2. When I pressed the trim button the new centre set wasn't where I had the stick held, it was always trying to centre on a different position. The problem was the S shaped axis curves that I'd added from the start for X and Y cyclic. The FF channel was still setting the new centre position as if the curve wasn't there, that was the difference between my stick position and the FF stick position. So the FF doesn't follow the axis curves you set? This is annoying as it means I can't calm the heli down with a softer response curve as it messes up the FF trim. As far as I can see this sounds like a bug, no? Edited January 26, 2009 by Mogster
ED Team USSR_Rik Posted January 26, 2009 ED Team Posted January 26, 2009 Did you perform Options - Controls - Axis commands - FF Tune - Swap Axis? It's necessary for MS FF2 . Men may keep a sort of level of good, but no man has ever been able to keep on one level of evil. That road goes down and down. Можно держаться на одном уровне добра, но никому и никогда не удавалось удержаться на одном уровне зла. Эта дорога ведёт вниз и вниз. G.K. Chesterton DCS World 2.5: Часто задаваемые вопросы
Mogster Posted January 26, 2009 Author Posted January 26, 2009 Yes I have swap axis set, for pitch and roll.
-sulan- Posted January 29, 2009 Posted January 29, 2009 I noticed this also, I also have a ms FFB2 stick. Very annoying, had to go back to having no curves on X and Y, as well as a very hard time hitting anything with rockets :P
Recommended Posts