A.F. Posted May 9, 2023 Share Posted May 9, 2023 (edited) Hi, since a few days i have the problem that the throttle in the plane changes to the cut off position, although i have the throttle only in the idle position. I have not changed anything in the Virpil software. When I move the throttle to the idle position, the two buttons that I programmed for the cut off are activated. This is new and should not be. Does anyone know a solution? MT-50CM3 Edit: I have found the error. Apparently my physical detent has been misaligned. Edited May 9, 2023 by A.F. 1 Link to comment Share on other sites More sharing options...
Recommended Posts