deltatango Posted June 9, 2023 Posted June 9, 2023 (edited) ***EDIT. FOUND IT WAS BECAUSE AN AXIS ON MY THROTTLE WAS MAPPED TO THE PCN BRIGHTNESS. I have never mapped any axis to this before. I do use the same axis for JHMCS brightness on other modules, so I'm not sure how this came to be in the M2000C*** Latest OB Update 2.8.6.41066 PCN display screen is blank. BAD REC VAL lights still lit. Happens in ST and MT versions. You can see the numbers briefly as the mission loads then it goes blank. I am using DCS UFC Android app to show PCN on a tablet and numbers still show on there (been using it for ages) Edited June 9, 2023 by deltatango found cause of issue Cheers, DT Junior Member for over 6 years. Difference between Ordinance and Ordnance. My X-52 Pro Profile. My Nevada training mission
Galinette Posted June 9, 2023 Posted June 9, 2023 Your PCN brightness is at zero. You most likely bound an axis to the PCN brightness. If you do so, and if your axis is at minimum when you spawn, DCS will sync the axis value after a short time, causing these exact symptoms (backlight on, then going off after a short time) Amber button backlights are not tied to the PCN brightness knob but the "Banquettes" light knob. And that's accurate. 1
Recommended Posts