Setting Laser to Auto

[JOEM423]

Hi All,

How do you set the Laser to Auto? The S4 Press says Declutter/Auto, I keep pressing S4 hat but all it does is declutter, How do you get the S4 Hat to set the Laser to Auto?

Thanks,

Joe

[draconus]

From the manual:

Quote

To change laser code, move the stick left side slider aft and release, this will change right hat (S4) into laser code mode. The currently selected digit will blink and the S4 hat can then be used to set the digits. Left/right change what digit to set and up/down change the value of the digit. Renewed selection of aft on the left slider will then exit the laser code mode.

If the right, S4, hat is depressed while in laser mode the automatic lase mode will be enabled, indicated by the M (for manual) left of the digits changing to an A (autolase). Repeat to switch back to manual mode. While activated, the autolase mode will begin firing the laser at 10 seconds TIMP until TIMP zero +4 seconds.

https://www.heatblur.se/F-14Manual/general.html#a-g-target-engagement-and-designation

Edited June 15, 2023 by draconus

[JOEM423]

7 hours ago, draconus said:

From the manual:

https://www.heatblur.se/F-14Manual/general.html#a-g-target-engagement-and-designation

 

Thank You