potinek Posted June 24, 2023 Posted June 24, 2023 (edited) Hello, According to manual (both Baltic Dragon's one and real flight manual) speed brake switch should stay in selected position, and speed brake should stop raising or retraction in middle (hold) position. In DCS F15E when using HOTAS binds "speed brake step aft" and "speed brake step fwd" it's not possible to put switch to HOLD position. It's only possible if I had a 3-position switch irl and then using speed brake AFT and speed brake FWD binds. Edited June 24, 2023 by potinek
FoxxyTrotty Posted June 25, 2023 Posted June 25, 2023 You don't need a 3 position switch, but you also can't accomplish a 3-switch-position-job (open/hold/close) using a single 2 position switch without a bit of "trickery"... so this isn't really a bug. You have 2 choices: 1) use 2x 2 position switches/rockets that do open/hold, and close/hold 2) watch the youtube video "DCS double your controls" and assign that process to a single 2 position switch. I hope this helps . . . . . . . Every module/ map except the dual winged joke.
WizzRD Posted June 25, 2023 Posted June 25, 2023 14 hours ago, potinek said: In DCS F15E when using HOTAS binds "speed brake step aft" and "speed brake step fwd" it's not possible to put switch to HOLD position. It's only possible if I had a 3-position switch irl and then using speed brake AFT and speed brake FWD binds. Use "Speed Brake AFT (Extend)" and "Speed Brake FWD (Retract)". These will stop whenever you let go the assigned button.
Recommended Posts