Jump to content

There is no way to set up AUTOMATIC AND MANUAL LASE


Recommended Posts

Posted

I choose M, then ARMT. I turn on GBU12C from above and press A/G DLVRY - PROG PAGE but I don't see the MLAS (ALAS) CONT function as the instructions on youtube or in the manual show.  LASER ARMED, A/G mode on, TGP on. The screenshot shows that I don't have this button. What am I doing wrong? 

P.S. I'm sorry, I speak English very poorly 😭 so I use an online translator. I hope you understand me.

 

1111.JPG

youtube.JPG

-

Posted

You choose auto or manual lase on the lantirn (tgp) pod screen it’s along the top row of buttons when you have it up on the mfd I believe the center osb and will cycle between manual and auto lase.

  • Like 1
Posted

I did see that it can be done in the ARMT section, but as per Sas, found that it could be done FAR more easily in the TPOD screen.

7800x3d, 5080, 64GB, PCIE5 SSD - Oculus Pro - Moza (AB9), Virpil (Alpha, CM3, CM1 and CM2), WW (TOP and CP), TM (MFDs, Pendular Rudder), Tek Creations (F18 panel), Total Controls (Apache MFD), Jetseat 

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...