Sequencing waypoints on the TGP stops at the last waypoint

[CoconutCockpit]

Sequencing waypoints on the TGP stops at the last waypoint

Version:

DCS v2.8.6.41363 Open Beta MT

Reproducible:

100%

Reproduce steps:

• Make a mission and add a couple of waypoints
• Open TPOD page on a MFD
• Press the OSB (Pushbutton 17) to cycle through the waypoints

Observed result:

After the TPOD points at the last waypoint, it doesn't cycle back to the first waypoint when Pushbutton 17 is pressed again

Expected result:

TPOD should cycle back to the first waypoint

tpod_sequence_issue.trk

[IanC58]

If you re enter the steer point in UFC i think that will reset the SP button?

[CoconutCockpit]

True, but I think it should still return to the first point in the sequence after it reaches the last point.

 

It doesn't explicitly say that in the manual...

Quote

NAV - targeting pod cued from NAV designation or quick step. Pressing PB 17 cycles through all available Sequence Points and cues the LOS to them. Pressing down Castle Switch on HC in rear cockpit selects next Sequence Point.

... but it is what the A/G radar does when you step through the points there. Unless someone actually knows for a fact it shouldn't, I think it makes sense the behavior is the same on the TPOD. 

[Maxter737]

As of now, my solution to this is to snowplow the pod and then go through the waypoints again.