Jump to content

Recommended Posts

Posted

Hi everyone,

I'm having this intermittent issue where the TPOD sometimes does the correct thing, which is, as long as MARK is selected in the MFD instead of TGT, etc it creates a markpoint based on where the TPOD is looking at. However, sometimes even though I follow the exact same procedure, once I do a TDC press it creates the markpoint based on where the plane is instead, as if I would've pressed the MARK button on the UFC.

Apparently what seems to cause it in my case are possible micro-movements of the TDC. I use a TM Warthog and it has the stupid 'nipple' type of TDC axis and press, so sometimes the TPOD moves slightly when I press the TDC, thereby creating the flyover points. It's hard to not move 'touch' the axis at all while pressing the TDC, although when I do 'perfect' presses without moving the axis at all it seems to behave correctly most of the time.

Is this a bug or as intended?

Pentium II 233Mhz | 16MB RAM | 14.4kb Modem | 1.44MB Floppy Disk Drive | Windows 3.1 with TM Warthog & TrackIR 5

Posted

Try setting a large dead zone for X and Y axis. That should help when you press the nipple and should reduce any unintended slewing. 

[sIGPIC][/sIGPIC]

i7 10700K OC 5.1GHZ / 500GB SSD & 1TB M:2 & 4TB HDD / MSI Gaming MB / GTX 1080 / 32GB RAM / Win 10 / TrackIR 4 Pro / CH Pedals / TM Warthog

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...