reported Simultaneous ACM SLEW and NO RAD indicators

[itn]

Hi,

Using DCS 2.8.7.42583 Open Beta

There are erroneous extra ACM SLEW mode indicators when returning to DGFT mode with no locked target, and having previously used ACM SLEW mode.

Steps to reproduce:

1. Enter DGFT override (radar enters ACM and NO RAD is indicated)
2. Enter ACM SLEW mode by slewing CURSOR/ENABLE switch
3. Lock a target
4. Return from DGFT override (to e.g. NAV and RWS)
5. TMS down to reject the target (so you don't have a target locked when you return to DGFT override in next step)
6. Enter DGFT override, and note the following
   - On HUD, there is "NO RAD" indication (correct) but also SLEW cues with the circle and elevation values (incorrect)
   - On FCR page, "SLEW" is indicated (incorrect)
   - You can slew around, radar will not radiate and lock a target (incorrect; it should enter slew mode when slewing)
7. You can enter any other ACM mode to lock a target, e.g. TMS up for BORE, after which you can also enter SLEW as usual.

Track attached.

Best regards,
itn

F-16 ACM SLEW NO RAD.trk

[Lord Vader]

Hi @itn

Thanks for bringing this up. I've raised this internally for analysis.