Jump to content

No correct guidance on the HSI and ADI


Go to solution Solved by razo+r,

Recommended Posts

Posted

Dear Eagle Dynamics, I would like to provide feedback on some bugs in DCS world. The game platform is STEAM, and the game version is MULTI THREAD PREVIEW2.8.7.42718. The bugs are like this.

In the map of the Caucasus, I am driving the A10C II to prepare to land on runway 07 at Kobuleti Airport(UG5X). I follow the following steps: 1. Turn on the power of the ILS panel and set the ILS frequency to 111.50; 2. Adjust the TACAN panel to T/R mode and set the channel to 67X; 3. Select TCN and ILS in the front navigation panel. I am certain that the airport runway is about 4 nautical miles ahead, but there is no correct guidance on the HSI and ADI. Instead, a warning flag appears, as shown in the attached image. The same problem will also occur at several other airports, such as Senaki Kolkhi(UGKS) and Kutaisi(UGKO). Not only does driving the A10C II cause the above problems, but driving the A10C also causes the same problems. It should be pointed out that after testing, when driving A10C II to land at Batumi Airport, HSI and ADI can work normally.

Please fix the above bug, thank you for your hard work!

Posted (edited)

It depends on a few factors if the ILS for a certain runway is activated or not. 

Is the runway you tried it with even the active runway? Contact ATC to confirm. 

Also, you forgot to attach your picture.

Edited by razo+r
  • Like 1
  • Solution
Posted

Yeah, seems you tuned to the ILS that was turned off because it's not the active runway.

Contact ATC to verify the active runway.

If you want to change the active runway, you have to add some wind to the mission to force a specific runway active. May not work with all airports due to terrain/obstacle clearance like in the case of Batumi.

  • Like 1
  • Thanks 1
Posted
15小时前,razo+r说:

Yeah, seems you tuned to the ILS that was turned off because it's not the active runway.

Contact ATC to verify the active runway.

If you want to change the active runway, you have to add some wind to the mission to force a specific runway active. May not work with all airports due to terrain/obstacle clearance like in the case of Batumi.

The problem has been resolved. Thanks for your great help!

https://tiebapic.baidu.com/forum/pic/item/ddeaf15c103853432c4e9512d513b07ecb808845.jpg?tbpicau=2023-09-19-05_46d96cd705cea6244f773e88bf543029

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...