DCS2TARGET: DCS to Thrustmaster HOTAS LED Controller (Viper Mission Pack, Viper Panel and Warthog)

[kennyuk77]

13 hours ago, slughead said:

Have you tried any of the Thrustmaster supplied scripts?

Yeah for some reason nothing works. I'm  using a TM AVA with the viper grip, Warthog throttle and the Viper TQS button box.

[slughead]

1 minute ago, kennyuk77 said:

Yeah for some reason nothing works. I'm  using a TM AVA with the viper grip, Warthog throttle and the Viper TQS button box.

You’ll need to contact Thrustmaster support to resolve this.

[Crass]

I was able to figure out what my problem was . Slughead you were right there was nothing wrong my setup.

My issue was I have the Winwing MIP and the software for it Simapp Pro wont let TARGET connect to the Viper panel if it running.

The fix was to keep Simapp off, start and run the Scrip from the editor. Once it was up running (Only takes few seconds now) then start Simapp and the Viper panel lights now works in DCS.

Thanks again for the great work you do.  

[slughead]

That’s great.

Whenever there’s a problem always go back to basics. Strip back to just what you need, test, then start adding back one at a time.

It’s the same with DCS. Remove all mods and start from the bare minimum. Add mods back until you find the problem,