FalcoGer Posted December 26, 2023 Posted December 26, 2023 (edited) When actioning the sight select switch to the FCR position, the FCR page should autopage on the left MFD. Should this also be the case when the TEDAC is showing the FCR page before actioning FCR as sight? As far as I know, the autopage logic does not pull up a page when it is already being displayed on another MFD, for instance when the engine page is already open on the right, and a fault occurs, it doesn't pop up on the left. I have seen the left MFD autopaging to FCR even if TEDAC is already on FCR, is that correct? Basically my question is, should the TEDAC be considered for autopaging logic? When the right MFD already shows the FCR page, does selecting FCR as sight autopage it on the left? If it does, is that correct behavior? I haven't been able to test this, but does it autopage to the other (right) MFD is the left MFD is showing the ADI, as flight instrumentation has the highest priority? Can this behavior be changed (no autopage) in some sub menus? Edited December 26, 2023 by FalcoGer
Recommended Posts