Rampster Posted January 27, 2024 Posted January 27, 2024 (edited) Hi, I had the issue that, once I go into ACM setup in the Viper, I couldn´t use vertical aqusition, borsight and so on. After some testing it tuned out that my TDC microstick had minimal inputs. Therefore I ended up in SLEW mode every time impossible to activate other modes in any ways. Solution was to define a deadzone. This is reproducable. I this on purpose, or a bug, because the imput is very minimal. cheers Edited January 27, 2024 by Rampster
Scendore Posted January 29, 2024 Posted January 29, 2024 I might have to look at this even though I replaced my Microstick on my WH with a very high end version with no drift. i can't get vertical acquisition and boresite to behave correctly. I hit the DF switch back to RWS then back and boresite will work but just one time. It's wonky.
Milker Posted January 30, 2024 Posted January 30, 2024 (edited) On 1/27/2024 at 2:19 PM, Rampster said: Hi, I had the issue that, once I go into ACM setup in the Viper, I couldn´t use vertical aqusition, borsight and so on. After some testing it tuned out that my TDC microstick had minimal inputs. Therefore I ended up in SLEW mode every time impossible to activate other modes in any ways. Solution was to define a deadzone. This is reproducable. I this on purpose, or a bug, because the imput is very minimal. cheers Yep, same here, Viper TQS, had to set deadzone of 6 on TDC and all good now! And I wasn’t having any TDC movement or spikes, it works fine! Edited January 30, 2024 by Milker
Scendore Posted February 1, 2024 Posted February 1, 2024 Okay I'm finally going to test this out tonight. It may be there is just enough movement with the microstick that it breaks. So I will try a deadzone and report back. I'll start with 6
Recommended Posts