Scendore

Mystery solved. You can close this thread. I have an updated curser in my Warthog throttle. It's really sensitive. If you touch it at all it brings up slew mode. I added a bigger dead zone and I have to mindful not to rest my finger on it and bingo. Sorry about that it was driving me nuts. Buttons are all good BTW.

Okay so here is a TRK for you to review. I was just simply flying around and when to Dogfight mode. I selected TMS down which puts the Radar into vertical mode. I flew around and uncommanded it went to a no radar boresite mode. I then select vertical again and this time on a few moments later it went back to a no radar boresite mode again. I'm not touching the TMS at all. I will attach the second file which is labeled Uncommanded you will see if I get into this no radar boresite I can't even get out of it. It's somewhat intermittent. Uncommanded 2 Boresite.trk Uncommanded Boresite.trk

Latest patch reverted to the old problems with the Dogfight Switch and radar modes not being remembered. Put her into DF mode and select your Radar mode such as vertical and it loses lock and you lose the mode. It exactly the way it was before you guys fixed it a few patches ago.

You are correct if you want to get the best rate out of the F-16 you need a slightly low nose attitude. And yes G onset is a different discussion.

It is a very interesting video that talks about the turn rate of the F-16.

I take it this problem has not been resolved. I'm keeping my Q3 on .62 for now until I hear otherwise.

Okay I'm finally going to test this out tonight. It may be there is just enough movement with the microstick that it breaks. So I will try a deadzone and report back. I'll start with 6

I might have to look at this even though I replaced my Microstick on my WH with a very high end version with no drift. i can't get vertical acquisition and boresite to behave correctly. I hit the DF switch back to RWS then back and boresite will work but just one time. It's wonky.

Best Corner Speed in the Viper is 450 or so knots with a slightly low nose. Currently you can't really sustain a 9G pull and it's very hard to modulate the throttle to get best corner speed. ED knows about it and it was mentioned by Wags during a podcast they are working on tuning the F-16 and F-18. It was also mentioned it also behaves strangely with certain configurations. The F-18 is also getting tweaked. C.W. Lemoine (former F-16 pilot) did a little testing a few days ago.

Still an issue with many of the sub modes of ACM. Intermittent at best. After the lock it will unlock then try to get in any other mode. No joy until I reswitch the dogfight mode. Something is broken.

I did noticed a few patches ago that switching from my normal Headset to the HP G2 in VR would not swap the sound normally. I now have to go into the game and switch the sound source for DCS to produce sound in the game. This was not the case about 3 patches ago. It would swap sources perfectly in and out of VR.

what did you do I'm having the same problem

Just throwing this out there... I was running DCS with pretty high settings and with the second round of MT in Open Beta I was getting 190 FPS on Growling Sidewinder's MP Server in the F-16 cockpit. The most recent patch dropped my frames down to 140 FPS same setup. This is not VR its 1440P My hardware I9 9900K @5 Ghz 32GB Ram 4090 GPU

Thank you for the response. So I did look up the 3 different modes for ECM and yes they only effect the Radar. With master arm on it would not release the 120. I will need to go through my HOTAS and see what is mapped. It could be some things are double mapped but I don't see how I could have anything like weapons release double mapped to my Warthog Stick. Can you also just send them pitbull with no radar lock like you can in the F-15?

I think I'm missing something when I use the ECM pod. I have it turned on and clearly you have NO Radar when ECM is running. But what I have run into is when I go to reengage after an exchange of Fox3s. I go defensive and once clear. ECM off TWS lock master arm on and I can't release the weapon. Yes I'm aware of the delay when holding the release button. Am I missing something?

I have the same issue as of today. And yes I am running (iCue) . It runs my fans on the water cooler as well. I didn't notice any stuttering but then again I'm not loading heavy missions at the moment. Running i9 9700K and 1080TI 32 GB ram

You may want to wait on getting any Card at the moment. AMD has released their benchmarks not 3rd party. I do hope it gives Nvidia a hard time. It's good for us end users. Also consider Nvidia has always responded to AMD by coming out with Tis and Supers in the last go. There is a reason Nvidia blew off their next cards 3080 and such with larger memory.

Watching this thread... Wanting to build a new rig. Mine rig is terribly old but still effective at 1440p.

My biggest gripe with CV1 was always resolution. Mostly more difficult to see aspect and IDing aircraft. Which is better for flight sim money no object. I left out Reverb because I don't want to deal with HPs hardware problems. I'm leaning towards S because Rift and their software has been around. Thoughts?

Good news is AMD is pushing Intel for the first time in a while. This will hopefully get Intel off their butts and force them to innovate. Also what ever happened to moving to Vulkan? Wasn't it supposed to help DCS scale?

I can't seem to find anything showing how the Warthog is setup by default.

Doesn't look all that impressive... I own a Rift and it looks like I'm going to wait for a real V2 version to come out. The res is just not quite there yet

Just for clarification... Do you need to be running an Alpha?

I think what is really missing is another study plane for the opfor. Meaning the only real opposition in terms of top fighters are the FC3 birds and they aren’t completely fleshed out. I think there are a lot of things they need to complete for this sim to round out. Perhaps I’m missing something but it seems incomplete.

Suggest you turn off SLI... See how it goes