Swiso Posted February 21 Share Posted February 21 Hello, assuming I want to change the designation of a waypoint from steer point to target point ( i.e from 3A to 3.A), how I should do it in the plane ? It is possible ? Secondly, how I should do to delete a whole route ? Sometimes with DTC for DCS when I send the planned waypoints to the plane, I see that the procedure go wrong... like the coords. on the scratch pad flashing... At this point how I should do to delete the whole route inserted so far, so to start adding a new clean route from the start ? Thanks ! Link to comment Share on other sites More sharing options...
Ignition Posted February 21 Share Posted February 21 Just type "3." to change it to a TGT or "3" to change it to a steer point in PB 1. To delete just type 0 in PB 1. Or you can build a B or C sequence. 1 1 Link to comment Share on other sites More sharing options...
Swiso Posted February 21 Author Share Posted February 21 (edited) 28 minutes ago, Ignition said: Just type "3." to change it to a TGT or "3" to change it to a steer point in PB 1. To delete just type 0 in PB 1. Or you can build a B or C sequence. Thanks, when home I will try it. Just to be sure, when I type 0 on PB1, all the subsequent waypoints of route A will be deleted ? Edited February 21 by Swiso Link to comment Share on other sites More sharing options...
Ignition Posted February 21 Share Posted February 21 (edited) Just now, Swiso said: Thanks, when home I will try it. Just to be sure, when I type 0 on PB1, all the subsequent waypoints of route A will be deleted ? No, you need to do it for each waypoint. Also, you can't change the ACTIVE steerpoint. Edited February 21 by Ignition 2 Link to comment Share on other sites More sharing options...
Swiso Posted February 21 Author Share Posted February 21 2 minutes ago, Ignition said: No, you need to do it for each waypoint. Also, you can't change the ACTIVE steerpoint. Thanks !! Link to comment Share on other sites More sharing options...
Recommended Posts