Changing waypoints designation and deleting route.

[Swiso]

Hello,

assuming I want to change the designation of a waypoint from steer point to target point ( i.e from 3A to 3.A), how I should do it in the plane ? 
It is possible ?
 

Secondly, how I should do to delete a whole route ?

Sometimes with DTC for DCS when I send the planned waypoints to the plane, I see that the procedure go wrong... like the coords. on the scratch pad flashing...

At this point how I should do to delete the whole route inserted so far, so to start adding a new clean route from the start ?

Thanks !

[Ignition]

Just type "3." to change it to a TGT or "3" to change it to a steer point in PB 1.

To delete just type 0 in PB 1.

Or you can build a B or C sequence.

[Swiso]

28 minutes ago, Ignition said:

Just type "3." to change it to a TGT or "3" to change it to a steer point in PB 1.

To delete just type 0 in PB 1.

Or you can build a B or C sequence.

Thanks, when home I will try it.

Just to be sure, when I type 0 on PB1, all the subsequent waypoints of route A will be deleted ?

Edited February 21 by Swiso

[Ignition]

Just now, Swiso said:

Thanks, when home I will try it.

Just to be sure, when I type 0 on PB1, all the subsequent waypoints of route A will be deleted ?

 

No, you need to do it for each waypoint.

Also, you can't change the ACTIVE steerpoint.

Edited February 21 by Ignition

[Swiso]

2 minutes ago, Ignition said:

No, you need to do it for each waypoint.

Also, you can't change the ACTIVE steerpoint.

 

Thanks !!