Jester interaction wheel incomplete display. VR

[[ED]Ben]

@jojo -  I also have reverb G2 - can you send me your options.lua so i can compare differences? All seems to work well for me, no cut-off - may help to see what we have set differently

 

[RangerGav]

Pimax Crystal here... had same problem with Jester wheel. I seem to have fixed it by setting the DCS resolution in the graphics options to 1280x960 (4:3). I already had VR settings set to use DCS resolution (right eye mirror). Previously I had it on the lowest resolution in the list (5:3 ratio) and that was cutting off the bottom of the Jester wheel (especially stuff like the ground air controls). 

Only just started the tutorials so haven't had the other Jester questions pop up yet (like asking to start alignment) - which was also previously cut-off and I couldn't do anything to interact with it.

[Mike_CK]

7 hours ago, Dentedend10 said:

For me wheel is visible now. All I had to do was click "use system resolution" in DCS mirror under VR tab

That didn’t work for me

I’ll post my options lua when I get home. I set it to 1200x800 but I’m thinking that b/c I have my mirror set to the 1024x680 option in the menu, I should set it to that. Maybe then it will be in the middle. I’ll give it a shot 

[jojo]

3 hours ago, [ED]Ben said:

@jojo -  I also have reverb G2 - can you send me your options.lua so i can compare differences? All seems to work well for me, no cut-off - may help to see what we have set differently

 

Hi,

I will do it when able.

Thanks

[cellinsky]

Pimax 8KX here (canted display, wide fov). Same issue with Jester menue partly visible and other overlays too. Headtracking works, but not as fluid as the one in the F14. Had two flights with the menue got stuck on screen. Could not get rid of it, wether with mouse nor keypresses. Other then this, fantastic module!

[Maduce]

Same problem for me with Pimax Crystal, Jester menu not usable

Edited May 24, 2024 by Maduce

[Grennymaster]

for me the solution was to activate the "use DCS solution" in the VR Menü, since then it works like a charm.

[Tygaris]

Managed to get it to work: RX6800 + HP Reverb G2, DCS MT, OpenXR but with SteamVR as OpenXR default runtime (otherwise the FPS are single digit)
 

System:
Resolution 1680x1050 (I normally set this as low as possible)

VR:
Mirror crop disabled
Use DCS resolution enabled

Special:
UI Resolution to 1680x1050

Everything (Jester menu + INS dialog, manual and bombing table) are visible now. But the mouse cursor is quite off when it changes from cockpit to UI frame. It works - kind of.

[olistotch]

You can also try to set Options->VR->Mirror Eye Source to BOTH. Helped in my case, playing with resolution had no effect.