VPC Calibration issue

[Turd Ferguson]

Hi,

A couple of months ago I had to reinstall Windows 10 and then recalibrate my Virpil bits.

Prior to this I could swap between the Hawk60 and Apache Grip for the collective base and the VFX and Warthog/Hornet grip for the CM3 base without have to re recalibrate it.

Since reinstalling Windows though everytime I swap a grip on either device the device isn't recognised and I have to run through the calibration in the VPC software again.

Does anyone know why? Is there a setting perhaps?

 

Thanks

[MAXsenna]

Hi,
A couple of months ago I had to reinstall Windows 10 and then recalibrate my Virpil bits.
Prior to this I could swap between the Hawk60 and Apache Grip for the collective base and the VFX and Warthog/Hornet grip for the CM3 base without have to re recalibrate it.
Since reinstalling Windows though everytime I swap a grip on either device the device isn't recognised and I have to run through the calibration in the VPC software again.
Does anyone know why? Is there a setting perhaps?
 
Thanks

You might need to make a profile per grip?

Sent from my SM-A536B using Tapatalk

[Turd Ferguson]

Thamks @MAXsenna. I spoke to Virpil and they said it shouldn't have been possible to do it so seems like it was a fortunate quirk of my previous installation sadly.