Ringo Posted June 5, 2024 Posted June 5, 2024 hello, I have both polychop modules and my collective is reversed and crazy sensitive. if i pull collective i stay on the ground when you lower it, it gets full collective? I already went to adjust settings and inverted the controls on both. Any ideas? TIA JR
Dangerzone Posted June 6, 2024 Posted June 6, 2024 Inverting the controls should resolve this, unless the axis has issues. I'm assuming you have other modules, and don't have this issue, just with these 2 modules? Have you checked to see if the axis is bound to any other device/axis on another gaming device as well that could be interfering? 2
MAXsenna Posted June 6, 2024 Posted June 6, 2024 Inverting the controls should resolve this, unless the axis has issues. I'm assuming you have other modules, and don't have this issue, just with these 2 modules? Have you checked to see if the axis is bound to any other device/axis on another gaming device as well that could be interfering?And set it as a slider... Sent from my SM-A536B using Tapatalk 1
Ringo Posted June 6, 2024 Author Posted June 6, 2024 Gentlemen, not sure how I fixed it. I just undid all my Virpal controls remapped them? thank you both for your quick response, it was much appreciated. respectfully JR 1
Schlomo1933 Posted July 6, 2024 Posted July 6, 2024 (edited) After setting your axis . Loom down , there is a button called axis. Open it and set your axis to revers . And make check the point for slider Why so many people don’t know , how to set axis and bind buttons properly ? Edited July 6, 2024 by Schlomo1933 1
-orlok- Posted July 14, 2024 Posted July 14, 2024 On 6/6/2024 at 9:37 PM, MAXsenna said: And set it as a slider... Sent from my SM-A536B using Tapatalk Had DCS for decades but only realised this was a thing (even if id seen it my brain didnt take it in) but ensure any slidey axis are set as sliders. 1
MAXsenna Posted July 14, 2024 Posted July 14, 2024 After setting your axis . Loom down , there is a button called axis. Open it and set your axis to revers . And make check the point for slider Why so many people don’t know , how to set axis and bind buttons properly ? I assume it because their never told. And sometimes the users don't not notice it. I had a conversation about this with another user were he actually did not recommended doing this as he had never had any issues. Sent from my SM-A536B using Tapatalk Had DCS for decades but only realised this was a thing (even if id seen it my brain didnt take it in) but ensure any slidey axis are set as sliders.Yes. The stick, ministicks, rudder/torque pedals should be default non-sliders. Pretty much else should be. Sent from my SM-A536B using Tapatalk
Recommended Posts