SimApp Pro - messes with TM warthog T.A.R.G.E.T. software

[hreich]

When i have simapp pro started, and then I try to run my TM Warthog profile through T.A.R.G.E.T.,  winwing's sim app pro is locking my virtual device TM WARTHOG combined stick creation.  I found out in windows event viewer this line:

The application \Device\HarddiskVolume1\Temp\2pW24J2sEgHfirG2Z3HbvJF2W6b\WWTStream.exe with process id 35832 stopped the removal or ejection for the device HID\VID_044F&PID_0404\8&2a952cb2&2&0000.
Process command line: c:\Temp\2pW24J2sEgHfirG2Z3HbvJF2W6b\WWTStream.exe 
List of affected devices:
HID\VID_044F&PID_0404\8&2a952cb2&2&0000

One workaround is for me to first load my tm warthog profile through T.A.R.G.E.T.  , and then start sim app pro...I tried creating bat fle to start sim app pro application but id doesn't work - this is code to start simapp pro through bat file : ""start SimAppPro" "X:\Users\Hrvoj\AppData\Local\Programs\SimAppPro\SimAppPro.exe" but for some reason it doesn't work. It runs some code visible in cmd screen output, and it creates log files..

Edited December 12, 2024 by hreich

[_Hoss]

Turn off SAP. Use it only to switch settings from Axis to buttons and make Firmware changes. There is no need to run it at all. I've got a mix of WW and TM devices and stopped using TARGET to program the TM products. I use RSMapper now, and you don't need vJoy, which I hate. RSMapper sees all your devices, and it is even easier to program than TARGET, which I was pretty good at. You can build multiple profiles for all your Modules quickly and easily. I can do command on press, command on release, Tempo commands, and Chain events, which it mistakenly calls Sequence events.

This is the mess I deal with every time I fly. I also have a BlackHog A panel, a K51 Trim box, TPRs, and an On your 12 Master Arm panel. Not pictured is an FFGG AH-64 keyboard. It all works flawlessly. I tore it all apart to have my office back and will start an NLR Flight Sim Pro set up after Christmas. I already have the new computer, but it's not shown either.

I believe in the KISS method of component programming. When fecal matter hits the rotating cooling device, less troubleshooting is needed.

 

 

 

 

 

Edited December 13, 2024 by _Hoss

[Phantom711]

vor 13 Stunden schrieb _Hoss:

 

Turn off SAP. Use it only to switch settings from Axis to buttons and make Firmware changes. There is no need to run it at all.

 

That depends on the WW devices the OP is using. If he uses the UFC, ICP or the MIP displays, then SAP is very much required to run, otherwise you won‘t get anything from DCS to display on those devices.

[hreich]

Managged to fix the problm...i have bat file to start DCS, Helios, Olympus, TrackIr, TM Warthog t.a.r.g.e.t. and  after that SIMAPPpro - and then closes CMD window so no visible code in cmd creen (which is some output from simapp pro - it looks like some script runs when i launch simamppro and i need to close CMD window with exit command) Now TM warthog script loads im 1 second, and in the end i launch simap pro which is blocking creation of TM warthog combined profile for some reason)