JG7_X-Man Posted January 2 Posted January 2 Can someone validate if Autoland still works? I haven't been able to get CPL P/L at 6 miles. I press the CPL button and nothing happens - it worked fine before this last patch!
Amarok_73 Posted January 3 Posted January 3 I did it about 3 days ago, without any trouble. Observe the ACL display and verify if the DATA comes to You. 1 Natural Born Kamikaze ------------------------- AMD Ryzen 5 3600, AMD Fatal1ty B450 Gaming K4, AMD Radeon RX 5700 XT, 32 GB RAM Corsair Vengeance LPX, PSU Modecom Volcano 750W, Virpil Constellation Alpha Prime on Moza AB9 base, Virpil MongoosT-50CM3 Throttle, Turtle Beach VelocityOne Rudder.
JG7_X-Man Posted January 3 Author Posted January 3 Thanks for confirming! I get the DATA and I see AUTO PILOT engaged on the DDI but the CPL doesn't engage - I don't get the ":" light next to CPL thus the simulation doesn't happen.
JG7_X-Man Posted January 3 Author Posted January 3 9 hours ago, Amarok_73 said: I did it about 3 days ago, without any trouble. Observe the ACL display and verify if the DATA comes to You. Can you please post your .miz if possible. It might be a setup issue on my end.
rob10 Posted January 4 Posted January 4 If you post a track someone will likely be able to tell you what you're missing on your end (or at least confirm it is an issue your end rather than an ED issue).
JG7_X-Man Posted January 5 Author Posted January 5 Can someone pls take a look at this track and let me know what I am doing wrong? Thanks! LastMissionTrack.trk
Solution Minsky Posted January 5 Solution Posted January 5 56 minutes ago, JG7_X-Man said: Can someone pls take a look at this track and let me know what I am doing wrong? My guess is that you wasn't fully configured. I took control at around 5.5nm, extended flaps from half to full and then coupled the ACL without any issues. FYI: While it's possible to couple as soon as the tadpole appears at 6nm, I would recommend taking your time to double-check everything, completing the landing checklist and engaging ACL at about 4nm. 1 Dima | My DCS uploads
JG7_X-Man Posted January 5 Author Posted January 5 (edited) @Minsky Thank you for taking the time to help me figure it out! User error - I wasn't going to full flaps, thus not correctly configured. Edited January 5 by JG7_X-Man
Recommended Posts