Trimming nose up/down and force Feedback joystick

[havebug]

I own a Rhino FFB and downloaded the Viggen a few days ago in Trial mode. So, I'm pretty new to this module, but one thing I noticed is that when I trim the nose up, the stick moves slightly forward (contrary to the trimming action). The same thing happens with the nose-down command. Apparently, this behavior cancels out the trimming, resulting in no noticeable change.

Trimming left and right works fine—the stick tilts to the left and right as expected.

The altitude autopilot (assuming it works like the F-14's) has no effect, and I haven't been able to get it to work so far...

[MAXsenna]

I own a Rhino FFB and downloaded the Viggen a few days ago in Trial mode. So, I'm pretty new to this module, but one thing I noticed is that when I trim the nose up, the stick moves slightly forward (contrary to the trimming action). The same thing happens with the nose-down command. Apparently, this behavior cancels out the trimming, resulting in no noticeable change.
Trimming left and right works fine—the stick tilts to the left and right as expected.
The altitude autopilot (assuming it works like the F-14's) has no effect, and I haven't been able to get it to work so far...

Other Rhino users may chip in with their experience/setup, while your issue is easy to workaround. Click and select the Rhino column the Controls Settings. Click the FFB tune button on the bottom row. Select check the "Invert Y axis" checkbox, and "OK" out.
Cheers!

Sent from my SM-A536B using Tapatalk

[havebug]

Thanks, you saved my trial days.

I'll definetely buy the module.

[Blaze1969]

Thanks MAXsenna!!

I had the module previously and it worked fine. I bought the Moza FFB stick and couldn't figure out what was going on with the Autopilot struggled a bit until I found this thread.

Also, thanks havebug for posting the issue.