Returning and Need New Help

[PacFlyer23]

Hi all. Well I've been missing in action the past month dealing with a horrible drop in FPS from 90 to 5-6. I got lots of sound advise and suggestions here, but no joy on a solution. I even pulled my Nvidia 4070 Super and sent to Gigabyte to have them check it. They found it was fine, and thought my PC might have a Motherboard or Power Supply issue. So I just decided to punt and got a new PC (AMD 9800x3d and NV 5070 Ti), which arrived last week.

I've been swapping over to it and thought today was the day. I got my Thrustmaster HOTAS and DCS software installed, the WinWing PTO2 and UFC/HD hooked up, DisplayLink , Reshade, and SImAppPro installed, and finally the three MIPs. Everything seemed to eventually work, but the displays are not saving their settings. I go into WIndows 11 and set the WW displays to under the main display and in portrait orientation, then into SimAppPro to configure. Start DCS and they work correctly. Exit DCS, and shutdown my PC... restart... and its back to the incorrect displays and layout - Landscape and not recognized in SimAppPro. 

My old PC would keep the WW MIP setup after being shutdown. Now every time I start up my PC I have to go into Windows 11 Display settings and then SimAppPro to configure them. Thoughts on what I'm doing wrong?

Edited Tuesday at 04:39 AM by PacFlyer23

[Weasel]

I have exactly the same issue. After every start of Windows 11 I have to set up my displays. I really hope there is a solution to fix this!  

[MustangSally]

7 hours ago, Weasel said:

I have exactly the same issue. After every start of Windows 11 I have to set up my displays. I really hope there is a solution to fix this!  

High powered USB3 hub and plug your screens in side by side. This is a Windows/USB issue. Nothing to do with WW

[PacFlyer23]

31 minutes ago, MustangSally said:

High powered USB3 hub and plug your screens in side by side. This is a Windows/USB issue. Nothing to do with WW

Could you clarify this a bit. I currently have a Sabrent 10 Port USB 3.0 Hub (60W) with this order  

1 - (R)MFD1

2 - (R)DDI

3 - (C)DDI

4 - (C)MFD1

5 - (L)DDI

6 - (L)MFD1

7 -open

8 - open

9 - PTO2

10 - UFC/HUD 

What is your recommended order?

I've also seen some post online that it's an issue with AMD and its boot up overriding Windows 11 settings. 

[MustangSally]

Plug your 3 screens in to the hub side by side...as in screen 1 into USB1, screen2 into USB2 and screen 3 into USB3! I'm only talking about the WW screens

null

Edited yesterday at 12:38 AM by MustangSally

[MustangSally]

Nothing to do with AMD, it has everything to do with the way you have them plugged in and what you have them plugged into.

 

[PacFlyer23]

Wow... That Did It. Definitely not an intuitive solution, but it worked. Thank You!!