Question on Chuck's guide controller setup

[vampyrgtr]

I noticed that the controller setup seems to be missing some controls, as shown in Chuck's guide for the KA-50.

I've taken a screenshot and attached it on what I am referring to.

I also noticed that there is no listing of the base of the Warthog Throttle.  It's almost like an entire page may be missing.

nullAnyone have suggestions on what should be completed?

 

[Akiazusa]

Looks like it's 95% mapped with buttons/switches on the real Ka50 stick/collective.

The only thing missing is

Quote

ADJ FREE–TUR” Control selector for re-adjustment of the free-turbine (rotors) RPM governor. To low [RAlt + Numpad -] and to nominal [RAlt + Numpad +].

which is a switch on the collective,pretty useful if u want to descend rapidly.(evade radar missile)

 

I guess there aren't many switches on the real ka50's stick/collective to fill up the Warthog HOTAS.

 

I personally uses these panels/switches(which are not on the real ka50 hotas) quite often when flying/combat.

Quote

“MAN-AUTO” (Manual/Auto weapon control switch). Placing this switch in the up "MAN" position commands manual weapon and sensor control, and placing the switch in the down "AUTO" position commands automatic control. When in manual mode, computed launch authorization, automated gate tracking size, and vertical compensation Vikhr launcher to target are absent. You should only use the manual mode when the automatic mode is inoperative. [A]   (below Master Arm switch,let u override FCS launch authorization,so u can launch ATGM slightly out the FCS calculated range,u can usually launch it about 0.5km out range,it can still reach the target,pretty useful against SAMs like sa15 or tunguska )

Quote

Laser designator reset button   (reset LA,below HSI,personally I push it a lot since the laser on ka50 is quite easy to burnt out)

also these 2 panels:

(especially the 4 blue buttons on the left,also FD button will change the autopilot mode from holding to damping, pretty useful for hand flying,also u can just hold trim button for that,will do the same)

(mainly the 5 green buttons,(the reset one is already mentioned in Chuck's guide),and the laser arm switch(u can't always leave it to on,since the laser on ka50 is quite easy to burnt out) )

 

u could bind the remaining controls to them if u like.

Edited 12 hours ago by Akiazusa