L4key Posted August 16, 2009 Posted August 16, 2009 Hi - apologies in advance if covered already, I've had a look, so please direct me to thread if so. Since installing the patch my laser doesn't get the correct range. The labels on targets will say 3.9, so within cannon range, but when I designate the target in the Shkval the range comes up as over 5. Same happens with the missiles, the labels say about 5km out but then my desigated target range then comes up as 7? What am I doing wrong or what have I missed, the two were in sync before.
barra733 Posted August 16, 2009 Posted August 16, 2009 Check your settings I noticed the same problem but had my settings set to imperial (miles) whilst the laser reads out in metric (Kilometers). 1
Tango Posted August 16, 2009 Posted August 16, 2009 Hi, A couple of things: * If it is raining, be sure to use the wiper for the Shkval * The laser can start to malfunction if it is used for too long (I'm not sure if it can fail - I think it can). There will be periods it will not fire as it is in the cool-down phase. * Try cycling the system and re-acquiring the target. Do a RESET. This will reset the laser (stop it firing) and will reset the Shkval. Best regards, Tango. 1
L4key Posted August 16, 2009 Author Posted August 16, 2009 Barra - you're a genius. Well I'm a bit dim, but I've just tried it and you're correct! Tango, cheers too. :thumbup:
barra733 Posted August 16, 2009 Posted August 16, 2009 Not often that I get called a genius! Had to show my wife...
Recommended Posts