A-10C - Center stick, plane rolls left + pitches up

[ClearDark]

Hey guys,

 

I'm running A-10C with an X-52 Pro on Simulation settings. My Roll/Pitch axes are set with 5 deadzone and 30 curvature. In the joystick settings under Control Panel I see the stick dead center (when left untouched). Also Axis Tuning in game shows that when the stick is untouched its well centered and off the deadzone limits. However when I unpause the simulation from Instant Action if I leave my stick untouched the plane will roll left and pitch up until I offset it with some movement and trim it.

 

Is this normal or is something seriously fubared with my settings?

[159th_Viper]

Hey guys,

 

I'm running A-10C with an X-52 Pro on Simulation settings. My Roll/Pitch axes are set with 5 deadzone and 30 curvature. In the joystick settings under Control Panel I see the stick dead center (when left untouched). Also Axis Tuning in game shows that when the stick is untouched its well centered and off the deadzone limits. However when I unpause the simulation from Instant Action if I leave my stick untouched the plane will roll left and pitch up until I offset it with some movement and trim it.

 

Is this normal or is something seriously fubared with my settings?

 

Roll deviation - Asymmetrical load. Pitch deviation - Throttle setting/Speed etc etc. As you said, trim for level, hands-free flight.

 

Your settings are fine.

[Shaman]

Welcome to simulated flight, ClearDark :) Trim, trim and trim again :)

[ClearDark]

Hey Shaman, I remember you from VVS504 :)

 

I'm not new to the sim world, I'm aware of the constant need to trim (Was more so in Russian jets) but I was just wondering if something is messed up with my settings because I do remember starting IA a few times with the plane flying perfectly level.