X52 pro programming issue

[pilotbaxter007]

Hi

 

I'm trying 2 use the sst software to assign the small rotary knob (the one by the clutch on the throttle) to increase/decrease shkaval (*really bad spelling*) tracking gate size (need to assign [ and ] to opposite directions on rotary wheel). I've tried a few different things, but when i load up a dcs flt, uncage shkaval and then try to adjust the tracking gate size, it changes size, but then will either keep getting bigger or smaller depending on whether i increased or decreased the size using the rotary knob.

 

Plz help me, i just got this x52 pro today, i love it but just need to fix this one stupid issue. If it's repeating the command, then how do i stop it, so one "notch" on the rotary wheel = one "press" of either [ or ], and once the command is done, it doesn't do anything until i rotate the knob again?

 

Thanks, and please help

[EtherealN]

I'm not sure if that is actually possible - the gate size isn't an axis, but the rotary is.

[Boulund]

It should be possible, if I'm not mistaken, to make bands of the rotary axis so that you can have one band in the center position that does nothing.

Bad ascii:

 

 

<----------------|--------------|------------->
    gate size -     (nothing)     gate size +

 

Then you can center the rotary so that it stops sending the command.

[Bucic]

Load up my profile and enjoy ;)

 

 

http://forums.eagle.ru/showthread.php?t=53213&highlight=advanced