Sully Posted August 18, 2012 Posted August 18, 2012 Hi all, I've opened the 10308 ports TCP and UDP for the system I'm hosting on, still no joy. I've looked at trying to enable Upnp but it looks like it's not supported on the 2WIRE router. Any suggestions would be greatly appreciated. :joystick::pilotfly:
S77th-ReOrdain Posted August 18, 2012 Posted August 18, 2012 Hi Sully, welcome to the forums. Open the UDP port the same way you set the TCP port. The radio button for UDP should be right next to the TCP button (at least its this way in my version of the software). Just repeat the process, selecting UDP instead of TCP. No need to set the protocol timeout, or the map to host port. Default should work fine for these two settings. Once you've done this, you should see both the TCP and UDP port settings in the Definition List at the bottom of the page. Hopefully helpful.
Sully Posted August 18, 2012 Author Posted August 18, 2012 Hey Reordain and thanks for the quick response. I've got both TCP and UDP 10308 showing in the definition list for the user defined program, and I've got that program assigned to the computer I'm hosting from... still nothing. I've got a new tool-set for my birthday with a nice hammer that I might try out next....
S77th-ReOrdain Posted August 18, 2012 Posted August 18, 2012 Sully, I just re-read your post and see that UDP was not your issue. I should refrain from posting before falling off to bed.:D I'm no expert, but I'm pretty sure you need not worry about Upnp. Try checking windows firewall (assuming you're running Windows OS) and confirm that dcs.exe is listed as an allowed program.
Sully Posted August 22, 2012 Author Posted August 22, 2012 Still no luck. I've diabled windows firewall, made sure norton was off AND added the program to the exceptions list. Still nothing. :joystick: Running out of options here! AHHH!
Recommended Posts