PVI-800 export in 1.2.1

[JG14_Smil]

Hello, need a bit of help.

 

Afraid I have forgotten all the edits I need to have my PVI-800 exported. My monitor setup file is all ready to go with the viewport, but I need the edits for the PVI files to make it work in 1.2.1.

 

thanks.

Edited October 30, 2012 by JG14_Smil

[JG14_Smil]

Hello,

 

I have the PVI displaying now, but it stays at "x0,y0", instead of being located at "x3340,y315". It does this if I am in Windowed or full screen/SoftTH mode.My monitor config file is unchanged from 1.2.0. (which displayed the PVI perfectly.)

 

If anyone has the PVI-800 displaying properly on your multi monitor setup after 1.2.1, please send me a P.M.

 

thank you.

[PeterP]

Do you have the same experience as in this post?

 

http://forums.eagle.ru/showthread.php?p=1584250#post1584250

 

Icemakers edits aren't fully compatible with dcs 1.2.1 when you follow his instruction to the dot.

 

A) Please post your init.lua for the PVI-800 and your viewporthandling.lua

 

or

(maybe simpler and quicker as going through the debugging)

 

B) use the files that are provided via the link in post #2 and set up a new monitorsetup.lua that has the changed naming for the exports.

Don't worry - the files will work fine in 1.2.1, even if they are still named "All_Exports_ON_for A-10C_and_Ka-50_in _DCS World_1.2.0.zip"

[JG14_Smil]

Thanks Peter, I finally found your reply here. I'll look into this and report back.

[JG14_Smil]

Thanks once again Peter, your pvi_init file fixed me right up.