Taproot Posted May 7, 2013 Posted May 7, 2013 (edited) Hi My Hotas has been perfect until today when I installed the drivers (been flying with the windows install drivers) and updated the firmware on both hotas and throttle. Now the plane randomly pull to the left, and only to the left. I see the virtual stick is pulled hard in the same direction. What did I do? :music_whistling: Edit: I tested the axis in some programs to check for corruption, but it was fine. It only happends in DCS. *shrugs* Edited May 7, 2013 by Taproot [sIGPIC][/sIGPIC]
Lausbub78 Posted May 7, 2013 Posted May 7, 2013 Maybe the Stick isn't calibrated properly anymore. You can see if thats the case when you open up TARGET Script Editor and click on Device Analiyzer. If it's off center you can use the TM Calibration tool found here at post #36 http://forums.eagle.ru/showthread.php?t=65901&highlight=TM+calibration+tool&page=4
hassata Posted May 7, 2013 Posted May 7, 2013 Check to see if axis has been assigned to other controllers or mfds. [sIGPIC][/sIGPIC]
Taproot Posted May 7, 2013 Author Posted May 7, 2013 Stick was perfectly calibrated. You headed me in the right direction Hass. I have the g940 Hotas connected since I use the 940 rudders. I disabled the 940 hotas driver a long time ago, but for some reason they where reinstalled when I ran the TM WH driver installer. Disabled it again, and everything is as it should be. :) [sIGPIC][/sIGPIC]
Recommended Posts