ozTRipwiRE Posted May 22, 2013 Posted May 22, 2013 Hi, I have been trying to finish the 'Battle' mission in Black Shark and have run into some problems. I attacked the enemy vehicles until the game said that the mission was 100% complete. I then requested permission to land with the tower. The tower said that I had permission to land on designated runway but did not state what that runway was. I then landed on what looked like the main runway. I seemed to do that okay but could not come to a complete stop even though I pressed 'W' (and held it down) to use the wheelbrakes. Coming to the end of the runway I took off again and landed on the other section of the runway to the right of the main runway (coming from the battlefield). Once again I could not properly stop so I shut off the engine to stop the aircraft. This did not finish the mission. This might sound like a stupid question but could anybody tell me what I need to do to finish this mission? I would appreciate it if anyone could help me out. Thanks in advance, ozTRipwiRE
Griffin Posted May 22, 2013 Posted May 22, 2013 (edited) Hi, there are no stupid questions. :) Are you flying in sim or game mode? Maybe you couldn't stop despite the wheel brake because you had too much forward trim on cyclic? Press Ctrl+Enter to see where your controls are. Then trim your cyclic to neutral and try stopping with brakes. Also the ATC doesn't really care where you land and the last time I flew (long time ago) properly the ATC did tell me the runway so I don't know why it didn't for you. Don't care about that too much though. The missions don't end automatically, you have to Esc and Quit. That's how it usually is in simulators. Edited May 22, 2013 by Griffin
Erforce Posted May 22, 2013 Posted May 22, 2013 i don't remember (or know) this mission. As Griffin said, missions don't end automatically, unless in multiplayer, where the mission editor can load the next one automatically. usually when the mission is complete, you can exit mission while flying. It just depends of the mission designer again. TASK / ROLES acronyms guide Black Shark A.I. datalink guide illustrated (v1.2.4 Available on Wiki) DCS World Codex 1.1 : full units list (Speed/Weapons/Armor thickness/Threat zone/Weapon damage...) (Oct 2013) BlackShark 2 1.2.x Bug and glitches thread (v1.2.7)
ozTRipwiRE Posted May 23, 2013 Author Posted May 23, 2013 Thanks for that information! Hi, Thanks very much for that information Griffin and Erforce, it is much appreciated. I did check that the wheelbrakes were utilised by the 'W' key on my system and they were. I was playing on Sim mode and I did make sure that I did not have too much forward trim on cyclic. Don't know what happened there. Least now I know that the missions don't automatically conclude when mission goals are completed so thanks for that. :) ozTRipwiRE
Recommended Posts