Jump to content

Recommended Posts

Posted

How do you do it? I attack first targets from 19,000 ft, 4 nm with wind, break off about 1 nm and climb 8,000 - 10,000 ft, reattack from 16,000ft. I usually circle within 5 miles from last attacked target.

AWAITING ED NEW DAMAGE MODEL IMPLEMENTATION FOR WW2 BIRDS

 

Fat T is above, thin T is below. Long T is faster, Short T is slower. Open triangle is AWACS, closed triangle is your own sensors. Double dash is friendly, Single dash is enemy. Circle is friendly. Strobe is jammer. Strobe to dash is under 35 km. HDD is 7 times range key. Radar to 160 km, IRST to 10 km. Stay low, but never slow.

Posted

I cant give you any strickt values as I mostly fly like I feel it will give me a good path for reattack.

 

Giving strickt values for altitude and distance is difficult as it depends on the weapons you intend to use, the kind of target(s) and how they stand in relation to each other.

 

I assume you want to do some divebombing with ironbombs. I tend to dive at -25° to -40° dependant on target armor (better armored, harder dive to reduce spread). If the wind is not strong I like to break off at about 10000ft-8000ft so I dont get close to the ground. If the winds are heavy and I'm quite sure I took out the enemy AD I go lower to get a better accuracy, because even with LASTE-settings your Impactcalculation is not accurate enough for suficcient hits from high altitude against armored targets

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...