engines
-
Posts
64 -
Joined
-
Last visited
1 Follower
-
Has anyone had any luck finding a configuration that works with the Harrier? I'm struggling to find settings that give the correct trim and stab/alt hold behaviour.
-
In DCS: Settings - Misc. - Force Feedback is enabled. Settings - Special - AV-8B NA - Force Feedback Enable Trim Offset is enabled. Settings - Controls - AV8BNA: Harrier control trims all rebound. FFB Fune - Swap Axis enabled. In Moza Cockpit 1.0.1.19: Force Feedback Mode: Direct Input. I have the F-14, but I don't fly it and it isn't configured. I'll have a quick look at that. Edit: I went to the Moza Discord and found this: https://discord.com/channels/976306826947743766/1256104835200188478/1290272053009842206 which seems to resolve the issue.
-
Apologies, I was unclear, ack that Mi8 doesn't have a trim hat. I was referring to general trim usage on other aircraft. FFB is enabled in settings. I've only had time to try the Moza once, so haven't diagnosed this properly. In the Harrier I flew last night, I was expecting the trim hat to move the stick but it did not. Does it need to be in "Telemetry" or "Direct Input"?
-
I expected that if I hit the trimmer button on Mi-8 or move the trim hat, the stick's spring center should move accordingly, but I'm not seeing that.
-
Sorry if this has been covered elsewhere, but I couldn't find anything, has anyone figured out trim recentering or trim feedback on the Moza?
-
Parts are in for the thirty throttle assemblies for those who put their deposits down! PXL_20240630_160519016~2.mp4
-
I am going to dump a few photos here of the recent work which includes development and testing of the throttle control module, angular position sensor calibration checks, and test prints of the grip. Note the final grip will be made from a single billet of machined 6061-T6 aluminum.
-
I'm opening up the first production run from 10 to 30. Please join the discord if you're interested in getting hold of one of the last couple of unallocated units. https://discord.com/invite/YExFSJrB
-
All the sheet metal arrived for the quadrant assemblies. Dimensional accuracy less than 0.5mm, which is within tolerance.
-
Try this one: https://discord.gg/aB9Qu4q2gG
-
The first 10 units have been provisionally allocated. I've started a reserve list in case anyone drops out. Join the discord group if you want to sign up: https://discord.gg/GKZAWQRnPK (this link is good for 50 people).
-
I've sent you a DM.
-
I mean, I could have finished it a year ago if I pulled my finger out. But I suspect you're referring to something else? Edit: Oh... making hardware for a module that may no longer be supported... Yeah, great timing.
