LindaBrownie

Try using the TGT/MSL REJ switch as that cycles through your mavericks.

For Dive Toss, set target altitude to 10ft to populate a drag coefficient. I was setting DT and inputting the bomb type on the Bomb Table and my releases were way off until I realised that setting just those two does not populate the Drag Coefficient. Flicking target altitude to 10ft seems to force the Drag Coefficient to populate and then my releases were on target.

Hi all, I'm planning on getting a new PC soon, I haven't found any solid guidance on transferring my keybinds from my old PC to my new one the easiest way. Do I have to save each input profile and transfer them over then load them individiually? Or can I simply transfer over my "Config" and "InputUserProfiles" and then not have to load up each profile individually (This i'm hoping for because I'm lazy). Thanks for any help!

16gb is borderline for even non VR DCS, especially on multiplayer. Made the upgrade to 32gb of ram a few months back on my older system, 1080 + i7 8700k, the performance difference was huge in regards to freezing and stuttering (Not FPS to a noticeable degree however). For sure that would be my first go to in this situation.

It should be "Weapon Release" for firing Rockets.

"Weapon Release" and "Trigger" are common but it's dependant on the module you are using.