BirdFarm

Anyone else having issues with some key binds? So far ive found that binding the radar mode selector (which should be in incriments) just goes from the full down rotation to full up. Ive also found binding the radio thumb wheels does the same and then gets stuck in the 0 position. It also skips the (2)xx.xxx and just 100 or 300 frequency, No matter where you are on the rest of them it goes either to 1 or 0 and once at 0 its not moving. Also in the bind menu the "ones" place is just called "Units", i dont know if thats on purpose or not. If i find more ill update here. Update: Radar control stick range when bound is either 60 or 7, it does not incriment

Any updates on the early A or A-6 AI? I know that's not the point of this post but I cant find any reliable information anywhere. cheers on the new AP system!

The forestall mast has a hitbox. Get creative.

Will there be line up lights off the back of the carrier like the SC has? Theres a red strip but nothing to tell you if your right or left of centerline. At least not that ive seen @bkthunderUse Rctrl+F9. Also LSO viewpoints work for me on every carrier

Forgive me if this has been asked already but what is the status of the last two A model variants? The A(early) and IRIAF.

The IFLOS has light bloom when looking back at it from the front of the boat. the bloom is pretty bad until at 3/4 of a mile from behind the boat

@dogsbody59Go into your config and delete your old binding files in the f-14 folder

If it hasnt been reported you can now drive the 14 around with the launch bar down. it wont lock out NWS

Its a static whine. It stays one tone the whole time. you can hear the old engine noise moving up and down underneath the whine. I dont mind the louder intake whine but it doesnt ever change pitch which gives me a headache after 10 minutes. It sounds like you're sitting on the ground, canopy open with one engine running idle.

Has anyone else had issues with the funky cockpit sounds? Its always a constant whine over the normal intake whine. The gear lever also sounds like a really light tab of metal as opposed to the clunk of a lever it was.