condor64

Hello Trying to use Harm in Too mode, cage/uncage doesn't work despite the sensor of interest is setting up into the good DDI ... Anybody with the same problem ? Thanks

IN DCS, the game see all view by keyboard action, F1 F2 F3 etc .....it'is ok but when the com menu is open, the similar touchs are not operating by using the mapping of my stick

Hi When using the communications menu, I can't use F1 to F12 keys mapped on my constellation... Any tip?

hi I found a way to make the x, y and z axes work on my cm3 accelerator but I cannot set up the rx and ry axes of the POV of my Alpha stick: there is no function adequate view in DCS axis controls

Hi Not recognized in dcs as POV, I had to assign 4 buttons to the RY and RX axes and it works; on the other hand the sensitivity is extreme .... Can we adjust it?

Hi I had mapped buttons 23/24 on my constallation in order to zoom in /out (slow zoom) of the view. It works (buffered encoders) but extremely slowly. Is there a way to speed up the movement? I don't find any tutorial about

Ok Thanks ; it was in the VPC Config

Hi Small problem which may not be one: for example on my cm3 accelerator, I configured buttons 10 to 13 with the number 9 to press. However, when I validate one of the 10 to 13, the number 9 is also activated .... Is this normal? Thank you for your help

Ok but when I bind logical buttons #25 with Keyboard "9" ans #28 with "8", the function repeats as if we were constantly pressed

"For the flip up trigger, I don't really have a use for it in the Hornet, though it could be useful to enable safe and armed and then bind the respective buttons to the master arm switch" But in the real, how do you bind with the VKBDevCgc ? ..the flip up trigger is not a button ...

Hello I know that some of you can add virtual knobs on the brake and trigger axes, but I don't see what assignment we could give them in dcs F18 ....

Hello I want to program DDi OBS buttons (without keyboard shortcuts) via VKBDevCfg software; is it possible ? thank you

Hello Is it possible to assign a pb"xx" key of a DDI on a hotas command (when there is no keyboard shortcut) ? Thanks for ansxer

Hi Once I have configured my virtual layer of my VKB Ultimate, how do I assign it to the DCS commands? Thanks

Ok tanks ; you don't program modifiers shift 1 or 2 , neither the gate/cont ?