Jump to content

[REPORTED]Switch guards not flipping the switches back


Recommended Posts

Posted

The guards for the GEN TIE CONTROL and GAIN switches do not flip the switches back when they're closed and the switch is put in the abnormal position. Instead, the guard just goes down and the switch stays in place, graphically glitching through the guard cover.

  • 5 months later...
Posted
The guards for the GEN TIE CONTROL and GAIN switches do not flip the switches back when they're closed and the switch is put in the abnormal position. Instead, the guard just goes down and the switch stays in place, graphically glitching through the guard cover.

 

I can confirm the GEN TIE switch does not flip back to normal when the guard is down. Guarded switched are designed so that when the guard is pushed back down the the switch is flipped away from the guard hinge. To reset a GEN TIE light in the FA-18 all you should have to do is lift the guard, move the switch to RESET then push the guard back down.

 

 

 

 

EDsignaturefleet.jpg

Posted
The guards for the GEN TIE CONTROL and GAIN switches do not flip the switches back when they're closed and the switch is put in the abnormal position. Instead, the guard just goes down and the switch stays in place, graphically glitching through the guard cover.

 

Can confirm here too.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...