Terzi Posted June 22, 2020 Posted June 22, 2020 I tried lofting some bombs to Khasab airfield in PG map. This airfield is inside a valley and the bombs were supposed to go over the hills. Staying low, while I get closer to the target, the CCRP symbology gets corrupted because there is a mountain between me and the target. If I go higher or keep line of sight to the target from different heading, the symbology is good again. I tried this 3 times and always the same issue. [CENTER] [/CENTER]
Deano87 Posted June 22, 2020 Posted June 22, 2020 Are you doing it with the TPOD active? If so after setting the SPI/Target point then turn the TPOD off. It’s the fact that the TPOD is looking at the hillside that causes it to move the target point. Without the TPOD interfering it should work fine. Proud owner of: PointCTRL VR : Finger Trackers for VR -- Real Simulator : FSSB R3L Force Sensing Stick. -- Deltasim : Force Sensor WH Slew Upgrade -- Mach3Ti Ring : Real Flown Mach 3 SR-71 Titanium, made into an amazing ring. My Fathers Aviation Memoirs: 50 Years of Flying Fun - From Hunter to Spitfire and back again.
Terzi Posted June 23, 2020 Author Posted June 23, 2020 Are you doing it with the TPOD active? If so after setting the SPI/Target point then turn the TPOD off. It’s the fact that the TPOD is looking at the hillside that causes it to move the target point. Without the TPOD interfering it should work fine. It was without TPOD. [CENTER] [/CENTER]
Terzi Posted June 25, 2020 Author Posted June 25, 2020 You don't really need track to replay. I describe the problem clearly. You have beta testers and it takes 5-10 minutes to setup and fly this. Just put a mountain between you and the target and watch the HUD. [CENTER] [/CENTER]
Recommended Posts