Shadoware Posted September 1, 2015 Posted September 1, 2015 I was trying to find a tutorial on how to use multiple reference gunsight correctly but I didnt find one. Could somebody give a little help? I didnt find good explanation in the A-10C manual. Many thanks!
Mike5560 Posted September 1, 2015 Posted September 1, 2015 I'm guessing you're referring to the pipper with three aimpoints? That would be the 4/8/12 reticle, with aimpoints for 4,000, 8,000 and 12,000 feet. It's primarily used when strafing low angle....particularly on mountainous targets where the normal CCIP gun reticle cannot compute a solution. 4000ft - .75 nm 8000ft - 1.3 nm 12,000ft - 2.0 nm I recommend reading the flight manual. Search for the word reticle.... I dont Have one with me but it's under the combat employment section. Switching the gun reticles is accomplished by pressing DMS left or right with the HUD SOI and master mode to GUNS.
Shadoware Posted September 1, 2015 Author Posted September 1, 2015 Thanks for the answer, but Im referring to the vertical bars that colapse in center of the HUB. Its locates bottom of the HUD. Look below, I found an interesting page: http://wiki.hoggit.us/view/HUD
Harzach Posted September 2, 2015 Posted September 2, 2015 From the manual: 3. Multiple Reference Gunsight (MRGS) The MRGS sight is composed of a series of 5 line segments pointing toward the Gun Bore Line, and spaced in an arc near the bottom of the HUD. The multiple lines represent multiple solutions for a target. MRGS lines continually collapse to the aircraft plane of motion. As each line reaches the plane of motion, it disappears and a new line is placed on the outside of the arc. The length of each line represents the preset target length and is used as a reference for target ranging. The MRGS is used by positioning the target parallel to one of the lines. The size and depression of the MRGS is determined by the fuselage length and airspeed data entered into the IFFCC AAS submenu. The lines are spaced at a distance from the GBL corresponding to ½ the input target velocity. When using an MRGS line, if the target is smaller than the line, it is either out of range or moving faster than anticipated, and requires extra lead. If the target is larger than the MRGS line, the target is moving slower than anticipated and will require less lead.
WildBillKelsoe Posted September 2, 2015 Posted September 2, 2015 could you post a screenshot with what you want? AWAITING ED NEW DAMAGE MODEL IMPLEMENTATION FOR WW2 BIRDS Fat T is above, thin T is below. Long T is faster, Short T is slower. Open triangle is AWACS, closed triangle is your own sensors. Double dash is friendly, Single dash is enemy. Circle is friendly. Strobe is jammer. Strobe to dash is under 35 km. HDD is 7 times range key. Radar to 160 km, IRST to 10 km. Stay low, but never slow.
Shadoware Posted September 5, 2015 Author Posted September 5, 2015 Im not figuring out how to use MRGS correctly! Based on the text I imagine MRGS will be used when you are pursuing another jetfighter. The gap between the bar mean something? Must I put the target behing MGRS and if the target is small than a bar lenght I change from pure pursuit to lead pursuit? Is It just that?
Recommended Posts