CyStryker Posted September 20, 2015 Posted September 20, 2015 Gents: I received a schematic of the Hall Sensor allegedly used in the Uber II Nxt gimbals... But neither the schematic nor the U2 material I have state the diameter, depth of the larger whole which the Hall screws into and the width and depth of the hole the single rod goes into... You can tell and see the small hole is machined to allow the shaft to fit in securely without play... but the units .. the Halls are $100.00 each plus shipping... Rolan d
Sokol1_br Posted September 20, 2015 Posted September 20, 2015 (edited) Midori QP-2H/2HC PDF say 3mm for axis diameter: http://www.midori.co.jp/e_pdf/orange/006-007-QP-2H-QP-2HC.pdf This picture (Cougar Word) show one these sensor (pre Uber NXTII kit) with bushing on axis to match original potentiotemer axis diameter. This kind of potentiometer have a ~5/6mm diameter axis. http://cougar.flyfoxy.com/images/cougar/Hall_and_OEM_pots.jpg You need find a way to measure his Uber NXT mounting hole, what is not difficult using a caliper. Edited September 20, 2015 by Sokol1_br
Stefem Posted October 14, 2015 Posted October 14, 2015 Gents: I received a schematic of the Hall Sensor allegedly used in the Uber II Nxt gimbals... But neither the schematic nor the U2 material I have state the diameter, depth of the larger whole which the Hall screws into and the width and depth of the hole the single rod goes into... You can tell and see the small hole is machined to allow the shaft to fit in securely without play... but the units .. the Halls are $100.00 each plus shipping... Rolan d the pics you mentioned shows the modifications needed to fit them on the stock gimbals.
Recommended Posts