Trimmer DCS 2.0

[bouncerj21]

Hi

 

I can't seem to see the issue on here already but is anyone having issues with the trimmer in DCS 2.0 ?

 

I can't seem to get it to work.

 

I fly the KA50 a lot in 1.5 but every time I set the trimmer the aircraft just pulls up. I here the click and release click but the controls don't get locked.

 

All autopilot apart from altitude hold are on.

 

Any ideas ?

 

Thanks

[Isegrim]

Central Position trimmer mode?

[bouncerj21]

Have tried with and without. I normally fly without

 

If I bring up the show axis control Rctrl + enter when I release the trimmer the input goes back to center every time and does not stay trimmed in position

[HoneyBadger]

I'm having the same issue on 1.5.

[dburne]

Sounds like you may have some conflicting controls in the bindings.

 

I would suggest going through all the control assignments and make sure there are no conflicting assignments - upon initial install DCS can assign some pretty strange stuff in there across the controls.

 

In both 1.5 and 2.0, first thing I did was wipe out all the default button and axis assignments and then set them each individually from scratch. Have not had any controller issues in either version.

 

Also I believe the default install enables FFB by default, be sure and disable if not running FFB.

Edited December 6, 2015 by dburne

[bouncerj21]

Hi dburne

 

sorted thank you. I disabled FFB and all working great

[dburne]

Hi dburne

 

sorted thank you. I disabled FFB and all working great

 

:thumbup:

 

You are welcome, have fun!

[HoneyBadger]

I did this as well and it's working now.

 

Thank you very much.