My F86 is twitchy

[AussieFX]

Hi, since the 1.5 update and now in 2.0 my x+y axis (roll and pitch) have become ultra sensitive.

To the point where it's unflyable, even the slightest twitch will send me out of control.

 

I don't normally use curves in any modules but it's so bad in the F86 I've had to drop the sensitivity of both axis to 50% and now it feels like a flying brick.

 

I didn't have any control problems in 1.2.x.

 

I'm using a Logitech G15. FFB.

Anyone else noticed a change, has there been a change?

 

Thanks.

 

EDIT my hotas is a G940 not G15...duh! Too much Logitech gear here.

Edited December 13, 2015 by AussieFX

[Fishbed-21]

Yes this happens to me too. I have tried all of my sticks (Defender Cobra M5, Thrustmaster T.16000, Logitech Extreme 3D pro) They are top end sticks but they do their work. I've also tried different settings for sensivity and dead zone.

[Sweep]

Same here, although for me this thing has been twitchy since I got it in February 2015...

 

I sorta got used to it.

[Buzzles]

Have you tried deleting (or renaming if temp) the f86 input diffs located here:

C:\Users\{username}\Saved Games\DCS\Config\Input\F-86F

and starting a fresh profile to verify it is not just a broken profile?

[Fishbed-21]

Have you tried deleting (or renaming if temp) the f86 input diffs located here:

C:\Users\{username}\Saved Games\DCS\Config\Input\F-86F

and starting a fresh profile to verify it is not just a broken profile?

Nope i'll give a try as soon as possible :thumbup:

[Slazi]

Flew last night with 1.5 openBeta. It seemed fine for me until I got up to around Mach 0.9. It was quite twitch at that speed.