Gambler1001 Posted December 28, 2015 Posted December 28, 2015 Hello, First of all I have to sat well done to the RAZBAM team. I have noticed a few bugs (or pilot errors, but prety shure it is bugs) When I go to AG mode select MK82SEs in the weapon panel I do not see the CCIP line. Did some testing and there is no setting in the cockpit that would give me the symboligy of the weapons. even when I went in to CCRP whit only Laser guided bombs loaded AKA MK82s, GBU12 etc I coudenlt get the symboligy to show. This allso happens whit AA weapons, were I will not see the symboligy on anny target that is locked ore in Uncaged situation. Puting in some pictures here. Thank you.
IvanK Posted December 28, 2015 Posted December 28, 2015 What does the small Open circle with wings just below the Horizon line represent ? I know it only comes up with a specific position of the HUD On/Off switch
Deezle Posted December 28, 2015 Posted December 28, 2015 What does the small Open circle with wings just below the Horizon line represent ? I know it only comes up with a specific position of the HUD On/Off switch That's the water line, the virtual point where the nose is pointing. There's one switch that turns it on. It looks like OP has two water lines, if you click the HUD power switch twice it goes into a test mode, this may be the problem. Intel 9600K@4.7GHz, Asus Z390, 64GB DDR4, EVGA RTX 3070, Custom Water Cooling, 970 EVO 1TB NVMe 34" UltraWide 3440x1440 Curved Monitor, 21" Touch Screen MFD monitor, TIR5 My Pit Build, Moza AB9 FFB w/WH Grip, TMWH Throttle, MFG Crosswinds W/Combat Pedals/Damper, Custom A-10C panels, Custom Helo Collective, SimShaker with Transducer
IvanK Posted December 28, 2015 Posted December 28, 2015 the manual indicates the Watrerline is much higher up around the IAS Altitude readouts. . If it was the waterline then the Velocity vector should at positive AOA be below the waterline :)
Flagrum Posted December 28, 2015 Posted December 28, 2015 The nose usually points up (WL) higher than the axis of movement (TVV) - aka AoA. So that can not be the water line - especially as the manual explicitely says that the HUD does not have a symbology for the WL. My guess: this is a placeholder for something due to WIP. Looks like it is taken from the Blackshark. :o)
il_corleone Posted December 28, 2015 Posted December 28, 2015 Put your Hud in the center position when Turning it on! looks like you have clicked two times on that switch!
Gambler1001 Posted December 28, 2015 Author Posted December 28, 2015 Thank you, that fixed it. Was so used to the Mirage in FSX that I dident mind looking there, now most is all good. just cant wait untill Buddy lassing and the INS is fully functional :D
AJaromir Posted December 28, 2015 Posted December 28, 2015 (edited) At 2nd picture that double mark is not bug. You just setted hud to its test mode. Just set the switch to middle position. Down is Off, Middle is On and top position is testing position. It's in the manual. Please, do not be lazy to read it. Edited December 28, 2015 by AJaromir
Recommended Posts