[RESOLVED]NTTR JTAC Datalink transmit target on TAD

[fearlessfrog]

Hi!

 

I have a very simple mission where I use JTAC with the A10C. The issue I am having is that the JTAC sent datalink red triangle target doesn't seem to be transmitted and displayed on the TAD in the A10C.

 

I am using DCS 2.1.1 (as of 21 June 2017). If I set up the same mission up in the same way in 1.5 then it does work as expected.

 

The steps to reproduce are:

 

1 - Contact JTAC on attached mission. You can do this from the starting position of the A10C at Creech from mission start at 133 MHz AM.

2 - Go through 9-line readback.

3 - After remarks and confirm, JTAC says 'sending datalink, standby'.

4 - No target is received in 2.1.1 TAD, while in 1.5 I get a 'Wilco' or CNCL option on the TAD plus the red hookable target.

 

I've attached the mission, in-case I've set it up wrong and it's not a bug. Thanks for any help.

a10-jtac.miz

Edited June 22, 2017 by BIGNEWY
TITLE

[BIGNEWY]

Hi fearlessfrog

 

I have taken a look, I did reproduce the issue, however after re-saving the mission all was ok again. Also when I test with our internal builds all is ok.

 

Can you resave the mission in the editor and let me know if you see a difference

 

thanks

[fearlessfrog]

Thanks for that. I thought I had resaved the mission a couple of times in 2.1.1 but I wonder if there were no pending changes then it didn't overwrite it? Anyway, I edited the flight to be a two-ship, resaved and now get my proper tasking. Cheers for taking a look, this one looks good.

[BIGNEWY]

Great news, thanks for letting us know