Radar Slew

[sphinx]

The radar slews all the way down. Even when I bring it back level it will go back all the way down.

Sometimes while I'm bringing it back up. I have checked the keys to slew it up/down. Is there another key I'm missing? I have it on my throttle.

 

Thanks for any help.

[Rex854Warrior]

The radar slews all the way down. Even when I bring it back level it will go back all the way down.

Sometimes while I'm bringing it back up. I have checked the keys to slew it up/down. Is there another key I'm missing? I have it on my throttle.

 

Thanks for any help.

 

Seems like one of your axis doesn't return to 0, when you release the slew it sticks at like -3% so it slews down all of the time, try and add some deadzone to it maybe ? I had the same issue and it fixed it for me (Warthog Throttle).

Edited September 11, 2017 by Rex854Warrior

[sphinx]

I have it on the hat switch on the front side of the throttle(warthog). Didn't know you could add a deadzone to those. I will give it a try. Thanks.

[drPhibes]

Check your axis assignments, and make sure that radar elevation isn't bound to a slider or something else where you don't want it. IIRC, I had problems with this happening to some aircraft (can't remember which) some time ago.

[Exorcet]

I've seen this as well. It will randomly happen, but only briefly correct? I can bring it back up and most of the time it stays put until a few minutes later it's back at the bottom. I know there is a common issue with double control bindings, so I checked for this and found nothing. The elevation will even go down while I'm pressing the up button and I've never seen it stuck going up.

 

At this point I'd say it's a bug in the software. The only other thing that I can think of is to unbind the elevation completely and see if it still happens. Might try this later.

[sphinx]

I found the problem. It was under the axis commands. I had checked the normal commands but not there. I cleared it and seems to be working fine now. Thanks for ya'lls help.