Jump to content

Recommended Posts

Posted

I am a newbie to mission editor so keep that in mind if my question seems ignorant. I have created a simple mission designed for MP so that me and my friends can practice ILS navigation. I have a group of f15c's and a group of a10c's. Both groups have 4 waypoints (0=initial, 1,2=fly over points and 3=landing). My question is with regards to the a10c. I set the ils freq based on the divert page info, turn it on and set nav cont panel to ils. I am able to fly the route but WP 3 brings me to the center of the runway. Shouldn't it direct me to the glideslope? I am also not seeing the yellow lines in the ADI during my route. What am i missing? Help would be appreciated.:doh:

Posted

The LANDING WP is always center of runway. If you want a WP near the final approach turn, you must place it yourself. To see the ADI needles you must, of course have the ILS panel switches and frequency correctly set, ILS selected in Navigation Mode Select Panel, needles uncaged, and then fly a course to intercept the glide slope within acceptable limits. Sometimes it is difficult to determine if the ILS power switch is in correct ON position. If so, and ILS tone volume is up, you should at least hear the ILS code tones.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...