Jump to content

Recommended Posts

Posted

Seen a few videos about how to set up the bomblet release altitude for the CBUs - from Wags and others - but for me it does not work as I understand it should work.

 

I select RET at the SMS page, select MFUZ and use HT to set my desired release altitude. Then pickle ... and F6-watch the canister to desintegrate at about 1500 ft. Every time, no matter which HT alt I had choosen - 300 ft ... 1200 ft ... 3000 ft. Same result every time.

 

See also the attached tacview file and examine the AGL of the canisters - they all end up at precisely 1500 ft (2 x 300 ft, 2 x 1200 ft, 1 x 3000 ft).

1695748638_cbu1500ftburst.gif.fc8dd01d5e735a7c66d74a6a9b768ccc.gif

Tacview-20180720-204822-DCS-ap1.trk.zip.acmi.zip

Posted

I suspect it's just not in yet. "Let's set it to 1500' for now." I see what you did there, Wags dealwithit.png

 

Couldn't ge them to pop open at other altitudes as well, didn't check it with Tacview though, but watching the impact areas alone tells it already since the spread is always in the same ballpark.

dcsdashie-hb-ed.jpg

 

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...